JVC hr-xvs30ek, Инструкция по эксплуатации

Страница: 71 / 84

Masterpage:Right-No-Heading
71
Filename [XVS30EK_10Subsidiary.fm]
Page 71 September 2, 2003 4:59 pm
NOTES:
●
Fine tuning is performed automatically during Auto Channel
Set. If you want to perform tuning manually, refer to page 72.
●
If you perform Auto Channel Set when the aerial cable is not
connected properly, “SCAN COMPLETED –NO SIGNAL–”
appears on the TV screen in step
E
. When this happens, make
sure of the aerial connection and press OK ; Auto Channel Set
will take place again.
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
墌
pg. 12), Preset Download (
墌
pg. 13) or Auto Channel Set
(
墌
pg. 70).
A
Access the Main Menu screen.
Press SET UP MENU .
B
Access the Confirmation screen.
Press
rt
to move the highlight bar (pointer) to
“MANUAL CH SET”, then press OK or
e
. The
Confirmation screen appears.
C
Select the channel position.
D
Select the band.
E
Input the channel.
Press the number keys to input the channel number you
want to store.
●
Input “0” before any single number entries.
●
To input the registered station name (ID –
墌
pg. 73), press
e
until “– – – –” (ID setting) begins blinking, then press
rt
.
●
For fine tuning adjustment, press
e
until “+/–” begins blinking,
then press
rt
. While tuning, “+” or “–” appears.
●
When “L-2 SELECT” is set to “A/V” or “SAT”, the “DECODER”
setting cannot be changed. (
墌
pg. 57)
F
Enter new channel information.
Press OK and the Confirmation screen appears.
●
Repeat steps
C
–
F
as necessary.
G
Close the Confirmation screen.
Press SET UP MENU .
●
To change positions, see “Change Station Channel Position”
(
墌
pg. 72).
●
If you wish to set station names other than the ones registered
in your unit, see “Set Stations (B)” (
墌
pg. 72).
Delete A Channel
A
Select the item.
Press
rt w e
until the item you want to delete begins
blinking.
B
Delete a channel.
Press
&
.
●
The item directly beneath the cancelled one moves up one
line.
●
Repeat steps
A
and
B
as necessary.
C
Close the Confirmation screen.
Press SET UP MENU .
Press
rt w e
until an open
position in which you want to
store a channel begins
blinking, then press
OK . The
Manual Channel Set screen
appears.
●
The blueback screen and the
programme currently being
broadcast by the selected
channel appear alternately for 8
seconds each.
(Example) To store in position 12.
Press
rt
to change the
band between CH (regular)
and CC (cable), then press
e
.
ATTENTION
Guide Program numbers are not set when channels are
stored manually. (
墌
pg. 24, “VIDEO Plus+ ® Timer
Programming”)
Perform steps
A
and
B
of “Manual Channel Set” on page 71
to access the Confirmation screen before continuing.
XVS30EK_01.book Page 71 Tuesday, September 2, 2003 5:01 PM