1-8 (No.YF183)
NOTE14:
When attaching, be careful with the wiring (STROBE).
NOTE16a:
Be careful in handling the HEAT SHEET.Pay special atten-
tion as it is easily peel off and soiled.
NOTE16b:
Refer to 3.2.3 DISASSEMBLY OF [16] OP BLOCK ASSY/
CCD BOARD ASSY of OP BLOCK ASSY.
NOTE17:
When attaching, remove the JACK COVER (MIC) to check
if the terminal is placed in the hole.
NOTE19a:
During the procedure, do not touch the CAPACITOR, and be
careful to avoid electric shock caused by the STROBE CA-
PACITOR.
NOTE19b:
During the procedure, be careful not to catch the WIRE
(MIC).
NOTE20:
When attaching, fix the SPACER and the MIC tight so that
there is no space between them.
NOTE21a:
When removing, remove the screw No.49 first to release the
FPC, and then pull out the FPC from the connector.
NOTE21b:
During the procedure, be careful not to damage the parts.
NOTE21c:
When attaching, be careful with the wiring.
NOTE22:
When attaching, be careful with the wiring.
NOTE24a:
During the procedure, be careful in handling the FPC.
NOTE24b:
Refer to 3.2.4 DISASSEMBLY OF [24] MONITOR ASSY of
MONITOR ASSY.
z
Destination of connectors
CN5
MAIN
CN102
HDD
-
40
CN8 MAIN
CN104 OPE.UNIT
- 10
CN9 MAIN
CN114 DIAL
OPE
- 12
CN11 MAIN
CN103
BATT.
- 6
CN12 MAIN
CN101
OPE
CN401 30
CN13a MAIN
CN109
STROBE
- 14
CN13b MAIN
CN107
MIC(INT)
-
4
CN13c MAIN
CN113
SENS
CN101 8
CN13d MAIN
CN112
MIC
-
4
CN14a MAIN
CN105
CCD
CN4201 39
CN14b MAIN
CN106
OP
BLOCK
- 39
CN21a OPE
CN402
MONITOR
CN7601 22/23
CN21b OPE
CN403
SPEAKER
-
2
CN.
No.
PIN
No.
CONNECTOR