JVC GZ-MG255US, Руководство по обслуживанию

Страница: 13 / 21

(No.YF180)1-13
3.2.3 ASSEMBLY/DISASSEMBLY OF [9] FRONT ASSY
z CAUTIONS
(1) As the FRONT ASSY has complicated structure, do not
disassemble if not needed.
(2) After reassembling, check the smooth slide operation of
the two BARRIERS.
z Disassembly procedure
(1) Remove the COVER (MIC).
(2) Remove the TORSION SPRING.
NOTE9a:
During the procedure, be careful not to break, deform,
or lose any parts.
(3) Remove the two SPECIAL SCREWS (1 and 2), and then
remove the BASE (BARRIER).
(4) Remove the SLIDER.
(5) Remove the KNOB.
(6) Remove the BARRIER (A) and the ARM together as as-
sembled.
NOTE9b:
Removing the ARM from the BARRIER (A) at a wrong
angle could cause damage or deformation of the at-
tachment part.
(7) Remove the BARRIER (B).
z Assembly procedure
(1) Attach the BARRIER (B).
NOTE9c:
Be careful with the attachment direction. Attach the
BARRIER (B) with its wrinkle side facing outside.
(2) With the ARM assembled, attach the BARRIER (A) by fit-
ting the ARM BOSS into the COVER ASSY hole.
(3) Attach the KNOB.
(4) Attach the SLIDER.
NOTE9d:
Attach the SLIDER by placing the KNOB hole and the
ARM BOSS parallel as shown in the figure.
(5) Attach the BASE (BARRIER), check if there is no uplift
or unevenness, and then tighten with the two screws (1
and 2).
(6) Attach the TORSION SPRING.
NOTE9e:
After the attachment, move the KNOB to check the
smooth operation of the two BARRIERS (A and B)
(7) Attach the COVER (MIC).
Fig.3-2-18
Boss of ARM
SPRING
TORSION
Boss of
BASE(BARRIER)
DITAIL OF KNOB AND SLIDER
KNOB
ARM
SLIDER
Adjust the KNOB hole
and the SLIDER hole.
Place the ARM BOSS
into the SLIDER frame.
Attach the SLIDER by placing the KNOB hole
and the ARM BOSS parallel.
L9a
L9b
SLIDER
ARM
BOSS
BARRIER(A)
BARRIER(B)
KNOB
BASE(BARRIER)
TORSION SPRING
L9c
NOTE9a,e
NOTE9e
NOTE9d
NOTE9e
NOTE9c,e
NOTE9c,e
NOTE9b
COVER(MIC)
1
(S9)
2
(S9)