52
EN
w
M– 0 : 1 2 : 3 4
PAUSE
FF
A.DUB
STOP
PLAY
REW
INSERT
START/STOP
Insert editing
indicator
Display
COUNTER R/M Button
Tape Counter
Remote sensor
Power Switch
Insert Editing (VIDEO)
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the remote control unit to perform this procedure.
1
Set the Power Switch to “
”. If the DSC Lamp is
lit, press
REFRESH
for approx. 1 second to select
“VIDEO”.
2
Play back the tape, locate the Edit-Out point and
press
PAUSE
(
6
).
3
Press and hold
COUNTER R/M
on the camcorder for
more than 1 second to reset the tape counter, then
press it again for less than 1 second so that “M”
appears.
4
Press
REW
(
2
) to go a little beyond the beginning of
the scene you want to replace, press
PLAY
(
4
) to
view the recorded tape, and press
PAUSE
(
6
) exactly
at the Edit-In point where the new scene should start.
5
Press and hold
INSERT
(
w
), and without releasing
INSERT
(
w
), press and release
PAUSE
(
6
). The Insert
Editing indicator appears and the Insert Editing mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
6
To begin Insert Editing, press
START/STOP
. When the
counter reaches “0:00:00”, editing stops automati-
cally and the camcorder enters the Insert-Pause
mode.
7
To end Insert Editing, press
STOP
(
5
).
NOTES:
●
During Insert Editing, the original audio will be heard
from the speaker.
●
After step
5
, Retake (
pg. 21) can be performed.
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only the video signal is recorded in the Insert Editing
mode.
USING THE REMOTE CONTROL UNIT
(cont.)
REFRESH Button
DSC Lamp
Microphone
