46
EN
1
2
3
4
5
6
7
8
IN
0:00:25
0:03:18
0:02:33
0:04:11
0:04:11
0:01:13
OUT
0:01:05
0:03:31
0:02:53
- - :- - :- -
COUNTER
TOTAL
1
2
3
4
5
6
7
8
IN
0:00:25
0:00:25
0:00:00
OUT
- - :- - :- -
COUNTER
TOTAL
SELECT SCENES
4
START SOURCE PLAYBACK
Point the remote control at the camcorder’s remote
sensor. Press PLAY, then press ON/OFF on the remote
control.
•The R.A. Edit counter display appears.
5
REGISTER BEGINNING OF SCENE
Press REW or FF to locate the beginning of the scene
you want, then press IN/OUT to register that point.
•The data appears under “IN” on the display.
6
REGISTER END OF SCENE
Press REW or FF to locate the end of the scene and
press IN/OUT to register it.
•The data appears under “OUT” on the display.
•The total time of the registered scene(s) is displayed
at the bottom of the screen.
7
REGISTER ADDITIONAL SCENES
Repeat steps 5 and 6 for each additional scene
(as many as 8).
8
MAKE CORRECTIONS (IF NECESSARY)
Press CANCEL during steps 5 and 6 to erase the most
recently registered point.
NOTES:
●
There must be at least one second between an in-point
and its corresponding out-point.
●
To ensure correct operation, there should be at least
15 seconds between an out-point and the next in-point.
●
Blank portions of a tape cannot be registered as in-points
or out-points.
●
If it takes more than 5 minutes to search for an in-point,
the VCR’s Record-Pause mode is cancelled and editing
does not take place.
●
Pressing ON/OFF clears all in- and out-points from
memory.
●
Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
●
Turning off the camcorder’s power erases all registered
in- and out-points.
USING THE REMOTE CONTROL UNIT (optional)
(cont.)
RM-V700U
(optional)
Remote sensor
Power Switch
REW
PLAY
IN/OUT
FF
PAUSE
ON/OFF
CANCEL
