JVC GR-FX101, Инструкция по эксплуатации

Страница: 30 / 61

46
EN
M 0 : 12 : 34
w
USING THE REMOTE CONTROL UNIT (optional)
(cont.)
Insert Editing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V700U remote control unit to perform this
procedure.
1
SELECT OPERATION MODE
Set the Power Switch to “PLAY”.
2
FIND EDIT-OUT POINT
Play back the tape, locate the Edit-Out point and
press
PAUSE on the camcorder or the remote control.
3
RESET COUNTER
Press and hold COUNTER R/M on the camcorder for
more than 1 second to reset the tape counter, then
press it again for less than 1 second so that “M”
appears.
4
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the
Edit-In point where the new scene should start.
5
ENGAGE INSERT EDITING MODE
Press and hold INSERT , and without releasing
INSERT , press and release PAUSE . The Insert Editing
mode is engaged. When the scene the camcorder is
aimed at appears on the screen, go to the next step.
6
BEGIN INSERT EDITING
Press START/STOP . When the counter reaches
“0:00:00”, editing stops automatically and the
camcorder enters the Insert-Pause mode.
7
END INSERT EDITING
Press STOP .
NOTES:
●
After step 5 , Retake (
墌
pg. 17) can be performed.
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only the video signal is recorded in the Insert Editing
mode.
RM-V700U
(optional)
Insert editing
indicator
Display
COUNTER R/M Button
Tape Counter
Rewind ( 2 ) Button
Fast-Forward (
3
)
Button
Play/Pause (
4
/
6
) Button
Stop (
5
) Button
Remote sensor
Power Switch
PLAY
PAUSE
REW
START/STOP
INSERT
STOP