JVC GR-DVM1, Инструкция по эксплуатации

Страница: 66 / 84

66
EDITING
(Cont.)
T W
6w
12:34
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording
with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
4 START RECORDING
Press RECORDING START/STOP to begin
editing.
•Confirm the insert at the time code you
checked in step 1.
5
PAUSE DURING EDITING
Press RECORDING START/STOP. Press again
to resume editing.
6 STOP EDITING
Press RECORDING START/STOP, then press
STOP.
1 FIND EDIT OUT POINT
Open the LCD monitor and turn the Power
Dial to "PLAY" while pressing down the lock
button located on the dial. Confirm the time
code at this point. (
Z
pg. 55)
2
FIND EDIT IN POINT
Press REW until the point is located, then press
PAUSE.
3
PREPARE FOR INSERT EDITING
Press and hold INSERT on the remote control,
then press PAUSE. “
6w
” and the Time Code
(min.:sec.) appear in the LCD monitor.
REW(IND)
PAUSE
PLAY
INSERT
DISPLAY
RECORDING
START/STOP
NOTES:
●
When performing Insert Editing, the tape’s Video Area and Sub-Code Area (
Z
pg. 77) are rewritten, so the date
and time information changes.
●
If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
●
During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting
stops and "ERROR: REFER MANUAL" appears on the LCD monitor.
RM-V708U (provided)
Remote sensor
Power Dial