62
EN
TROUBLESHOOTING
(cont.)
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
37.
The charge indicator on
the AC Power Adapter/
Charger does not light.
38.
The recording mode
indicator “LP” blinks.
39.
Picture does not appear on
the LCD monitor.
40.
Picture does not appear in
the viewfinder.
41.
When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
42.
The power lamp blinks.
43.
There are disturbances in
audio.
37.
•The temperature of the
battery is extremely high/low.
•Charging is difficult in places
subject to extremely high/low
temperatures.
38.
•This occurs when recording
in the LP mode is not
available. After the indicator
blinks, the recording mode
switches to “SP” and
recording goes on.
39.
•The lens cover is closed.
•The LCD monitor is not open
at an angle of over 60
degrees.
•The LCD monitor’s brightness
setting is too dark.
40.
•The lens cover is closed.
•The LCD monitor is open.
•If the LCD monitor is not
facing forward towards the
subject, Interface Shooting
will not be possible.
41.
•This is not a malfunction.
42.
•The camcorder was turned
on when the battery power
was almost gone.
43.
•If Audio Dubbing has
been performed
repeatedly on the same
portion of the tape,
disturbance to the sound
may result.
37.
• To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C (
Z
pg. 69).
38.
————
39.
• Open the lens cover
(
Z
pg. 14).
• Open the LCD monitor to an
angle of over 60 degrees.
• Adjust the brightness of the
LCD monitor (
Z
pg. 17).
• If the monitor is tilted
upward to 180 degrees,
open the monitor fully
(
Z
pg. 17).
40.
• Open the lens cover
(
Z
pg. 14).
• Close the LCD monitor.
• Open the LCD monitor and
tilt it upward 180 degrees so
that it faces forward
(
Z
pg. 17).
41.
• By recording with Picture
Stabilizer activated
(
Z
pg. 18) this can be
avoided.
42.
• Replace with a charged
battery pack (
Z
pg. 6)
43.
• Use a new, or infrequently
used, tape for Audio
Dubbing (
Z
pg. 56, 57).
