EN
53
Master Page: Right
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a
DV connector. Since a digital signal is sent, there is
little if any image or sound deterioration.
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit equipped
with a DV input connector using a DV cable as
shown in the illustration.
3
Set this camcorder’s
VIDEO/MEMORY
Switch to
“VIDEO”.
4
Set this camcorder’s Power Switch to “PLAY”
while pressing down the Lock Button located on
the switch.
5
Turn on the video unit’s power.
6
Insert the source cassette in this camcorder.
7
Insert the recording cassette in the video unit.
8
Press
4
/
9
on this camcorder to start playback of
the source cassette.
9
At the point you want to start dubbing, engage
the video unit’s Record mode.
10
To pause dubbing, engage the video unit’s
Record-Pause mode and press
4
/
9
on this
camcorder.
11
Repeat steps
8
–
10
for additional editing. Stop
the video unit and camcorder.
NOTES:
●
It is recommended to use the AC Adapter as the
power supply instead of the battery pack.
(
●
If the remote control is used when both the player
and recorder are JVC video units, both units will
perform the same operation. To prevent this from
happening, press the buttons on both units.
●
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step
9
. If
this occurs, turn off the power and make
connections again.
●
pg. 58) or “Playback Special Effects”
pg. 58) is attempted or
SNAPSHOT
is pressed
during playback, only the original playback image
recorded on the tape is output from the DV IN/
OUT connector.
●
When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.
Dubbing To A Video Unit Equipped
With A DV IN Connector
(Digital Dubbing)
Core filter
To DV IN/OUT
DV cable
(optional)
To DV IN
Video unit equipped with DV
connector
GR-DV801US.book Page 53 Wednesday, January 22, 2003 5:39 PM
