EN
55
EDITING
MasterPage: Start_Right
AD
V
A
N
C
ED
F
EA
T
UR
ES
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
●
Use the provided remote control.
NOTES:
●
Before performing the following steps, make sure
that “TIME CODE” for “CAMERA DISPLAY” and
“VIDEO DISPLAY” is set to “ON”.
(
墌
pg. 36, 39, 41)
●
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1
Play back the tape, locate the Edit-Out point
and press
PAUSE
(
9
). Memorize the time code
at this point (
墌
pg. 21) since it will be needed to
stop editing in step
5
.
2
Press
REW
(
3
) until the Edit-In point is
located, then press
PAUSE
(
9
).
3
Press and hold
INSERT
(
I
) on the remote
control, then press
PAUSE
(
9
). The “
9
I
”
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press
START/STOP
to begin editing.
●
To pause editing, press
START/STOP
. Press it
again to resume editing.
5
When the time code reaches Edit-Out point
(time code from step
1
), press
START/STOP
,
then
STOP
(
8
) to end Insert Editing.
NOTES:
●
Program AE with special effects (
墌
pg. 47) can
be used to spice up the scenes being edited
during Insert Editing.
●
During Insert Editing, the date and time
information changes.
●
If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
●
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. (
墌
pg. 59)
Insert Editing
GR-DF470-450US_07Advanced.fm Page 55 Monday, February 28, 2005 6:21 PM
