44
EN
Connections/Editing
Audio Dubbing
The audio track can be customised only when
recorded in the 12-BIT and SP modes (
31).
• Use the provided remote control.
1
1
Play back the tape to locate the point
where editing will start, then press
PAUSE
(
8
).
2
2
While
holding
A. DUB
(
D
) on the remote
control, press
PAUSE
(
8
). The “
8
D
”
indicator appears.
3
3
Press
PLAY
(
3
), then begin “narrating”.
Speak into the microphone.
• To pause dubbing, press
PAUSE
(
8
).
4
4
To end Audio Dubbing, press
PAUSE
(
8
),
then
STOP
(
7
).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”
(
29, 34).
Notes:
• Sound is not heard from the speaker during
Audio Dubbing.
• When editing onto a tape that was recorded
at 12-BIT, the old and new soundtracks are
recorded separately.
• If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only
edit recorded areas.
• If feedback or howling occurs during TV
playback, move the camcorder’s microphone
away from the TV, or turn down the TV’s
volume.
PAUSE
PLAY
A.DUB
STOP
REW
INSERT
START/
STOP
Insert Editing
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and out points. The original
audio remains unchanged.
• Use the provided remote control.
Notes:
• Before performing the following steps, make
sure that “TIME CODE” in both Recording and
Playback Menus is set to “ON” (
29, 34).
• Insert Editing is not possible on a tape
recorded in the LP mode or on a blank portion
of a tape.
1
1
Play back the tape, locate the Edit-Out
point and press
PAUSE
(
8
). Confi rm the
time code at this point (
20).
2
2
Press
REW
(
1
) until the Edit-In point is
located, then press
PAUSE
(
8
).
3
3
Press and hold
INSERT
(
I
) on the remote
control, then press
PAUSE
(
8
). The “
8
I
”
indicator and the Time Code (min.:sec.)
appear and the camcorder enters Insert-
Pause mode.
4
4
Press
START/STOP
to begin editing.
• Confi rm the insert at the time code you
checked in step
1
1
.
• To pause editing, press
START/STOP
.
Press it again to resume editing.
5
5
To end Insert Editing, press
START/STOP
,
then
STOP
(
7
).
Notes:
• Program AE, Effects and Shutter Effects
(
39) can be used to spice up the scenes
being edited during Insert Editing.
• During Insert Editing, the date and time
information changes.
• If you perform Insert Editing onto a blank
space on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
• During Insert Editing, when the tape moves
to scenes recorded in the LP mode or a blank
portion, Insert Editing stops.
Stereo Microphone
GR-D850&870AH_EN.indb 44
GR-D850&870AH_EN.indb 44
12/6/2007 1:11:41 PM
12/6/2007 1:11:41 PM
