EN
39
M– 0 : 0 5 :
e
2
4
0
PLAY
REW
STOP
PAUSE
A.DUB
START/STOP
Audio Dubbing
You can record a new soundtrack on a prerecorded tape.
The existing original sound is erased and replaced by the
sound from the built-in microphone.
Perform steps 1, 2 and 3 of the Insert Editing procedure
(
墌
pg. 38) before continuing.
NOTE:
Use the remote control unit to perform the following
procedures.
1
Press
REW
to go a little beyond the beginning of the
scene onto which you want to dub the new audio,
press
PLAY
to view the recorded tape, then press
PAUSE
at exactly the point where dubbing should
start.
2
Press and hold
A. DUB
, and without releasing
A. DUB
, press and release
PAUSE
on the Remote
Control. The Audio Dub-Standby mode is engaged.
3
To begin Audio Dubbing, press
PLAY
. When the
counter reaches “0:00:00”, Audio Dubbing stops
automatically and the camcorder enters the Audio
Dub-Standby mode.
4
To end Audio Dubbing, press
STOP
.
NOTES:
●
Do not press
FF
or
REW
during Audio Dub-Standby, or
the edit points will not be accurate.
●
If the microphone is too close to the TV, or if the TV’s
volume is too high, whistling or howling may occur.
NOTES
(for Insert Editing and Audio Dubbing):
●
Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if the
recording speed was changed during the original
recording.
●
To edit/dub onto a tape, make sure the Erase Protection
tab is in the position that allows recording. If not, slide
the tab. Some cassettes have removable tabs. If the tab
has been removed, cover the hole with adhesive tape.
●
Do not press
STOP
during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
●
During Insert Editing and Audio Dubbing, when
Insert-Pause or Audio Dub-Standby is engaged, the
counter may go slightly past “0:00:00”. Recording,
however, stops at exactly 0:00:00.
Microphone
During Audio
Dubbing
Audio dubbing
indicator
Remote sensor
Display
