JVC GM X50U, Инструкция по эксплуатации, Страница: 99 / 128

12
Connections
(Continued)
VIDEO
DISPLA Y
OFF POWER
RM–C579 REMOTE CONTROL UNIT
ON
ASPECT
MUTING
MENU/EXIT
VOLUME
A COMPO.
/(RGB B)
BRG B A
INPUT SELECT
❊
AC IN AUDIO
L
OUT
R
RGB A
AUDIO
IN
REMOTE
RS-232C
WIRED
MAKE
POWER
Typical connections
Personal computer
(used as the playback source)
Personal computer
(used to control the Monitor)
Cable with stereo
mini jacks
(not supplied)
T
o
monitor output
T
o
audio output
T
o
RS-232C
Remote control
(supplied)
Amplifier, etc.
T
o
audio input
Power cord
(supplied)
To a wall outlet
❊
For connection, see “Connecting an
External Control Unit” below.
Connecting an External Control Unit
When connecting the external control unit to the MAKE terminal, you can operate the following functions through the MAKE
terminal;
• Turn on or off the Monitor.
Preparation: The POWER switch on the rear must be set to “ | (on)” (so that the Monitor is in standby mode).
• Select the input.
Preparation: “REMOTE SWITCH” should be set correctly to select your desired input (see page 24).
Notes:
• There is no remote control on/off switch. When a plug is inserted to the MAKE terminal, remote control through the external
control unit is automatically activated.
• When the other REMOTE terminals are used at the same time, transmitted commands through the MAKE terminal have
priority over those through the other terminals.
IMPORTANT:
External control unit is not commercially available in the market. When you need it, consult your dealer.
• MAKE terminal
• External control unit
Pin number Signal name
1 GND
2 GND
3 SW2
4 SW1
5 SW DET
6 GND
Signals
transmitted
=
○ ○ ○ ○
=
○ ○ ○ ○
=
○ ○ ○ ○
TTL level
H: Power Off L: Power On
H: Input A* L: Input B*
H: Not connected L: Connected
* Input A and Input B will be determined by the “REMOTE
SWITCH” setting.
1 2
3 4
6
5
04-13_GM_X50S.p65 04.3.1, 2:41 PM 12