70
EN
Master Page: Left
GR-DVM96-76U_37-79.fm
Page 70
The audio track can be customised only when
recorded in the 12-bit and SP modes. (
墌
pg. 44)
1
Play back the tape to locate the point where
editing will start, then press
PAUSE
(
9
).
2
While holding
A.
DUB
(
D
) on the
remote control, press
PAUSE
(
9
). The
“
9
D
” indicator
appears.
3
Press
PLAY
(
U
), then
begin “narrating”.
Speak into the
microphone.
●
To pause dubbing, press
PAUSE
(
9
).
4
To end Audio Dubbing, press
PAUSE
(
9
), then
STOP
(
8
).
To hear the dubbed sound during playback…
Set “12BIT MODE” to “SOUND 2” or “MIX”.
(
墌
pg. 38, 51)
NOTES:
●
Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional
headphones to the headphone connector.
(GR-DVM96 only)
●
When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
●
If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
●
If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the
TV, or turn down the TV’s volume.
●
If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
●
During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
●
To perform Audio Dubbing while watching on the
television, make connections. (
墌
pg. 24, 25)
Audio Dubbing
PAUSE
PLAY
A.DUB
STOP
Remote sensor
Headphone connector
(GR-DVM96 only)
Speaker
Stereo microphone
Open the
connector cover.
9
D
MIC
GR-DVM96 only
USING THE REMOTE CONTROL UNIT (cont.)
GR-DVM96-76U_37-79.fm Page 70 Friday, February 15, 2002 11:55 AM
