JVC DT-V9L5, Инструкция по эксплуатации

Страница: 22 / 228

20
Remote Setting
Settings for the external control.
Item To do Setting value
Parallel Type Select a control method of the MAKE/TRIGGER terminal. Make, Trigger, Set
Pin1
Assign the control functions to the pins of the MAKE/TRIGGER terminal.
• Assign a function to each pin terminal by selecting “Set” in “Parallel Type” mentioned
above.
☞
"Display" in "Functions
controlled by the MAKE/
TRIGGER system" on page 24
Pin2
Pin3
Pin4
Pin5
Pin6
The functions are assigned for “Pin6” – “Pin8” and you cannot change the assignment of
these functions. Tally
Pin7 Enable
Pin8 GND
Information
Settings for the information display of the monitor.
Item To do Setting value
Source ID
Select whether the name assigned in “Character Setting” (
☞
below) is displayed on the
screen (
☞
“On the Information Display” on page 11).
• When “Auto” is selected, the display color synchronizes with the color of the tally lamp
while the tally lamp is lit.
Off, On, Auto
Character Setting Assign a name to each video source as you like (10 characters at maximum). You can also enter a name using the RS-232C
system. (
☞
Page 22)
Status Display Display/Hide the status of the current input and the setting of MUTING. (
☞
"On the Status
Display" on page 12)
Auto, Off, On
Time Code Display/Hide the Time Code. Off, On
Time Code Select Select the type of the TIME CODE display. VITC*
1
, LTC*
1
, D-VITC
CRC Error Display/Hide the CRC error when the HD SDI signal is input. (
☞
"On the Information Display"
on page 11)
Off, On
Sub Hour Meter Display the hours of use (unit: hour). The usage time can be reset to 0.
Model Display the model name of the monitor.
Version Display the version of the monitor.
Hour Meter * 2 Display the total hours of use (unit: hour). This item is used for maintenance of the monitor. You cannot reset this item.
* 1 Ancillary time code
* 2 ”Hour Meter” and settings specified using the Picture adjustment knob (
☞ 4
on page 10) are not reset.
Control Lock*
3
Setting values: Off, Volume Lock, All Lock
Settings for disabling the buttons on the front panel.
* 3 • The following operations are not available when “Volume Lock” is selected.
- Picture adjustment knob
• The “All Lock” function disables to control the buttons on the front panel. But following operations are available.
- Turning on/off (on standby) the monitor
- Displaying the Set-Up Menu by pressing button while holding button and turning “Control Lock” to “Off”
- Operating the monitor by an external control
If you try other operations, “Control lock on!” appears on the screen.
Language
Setting values: English, Deutsch, Français, Español, Italiano, Pуccкий
Select the displayed language for the menu, etc.
Menu Configuration (cont.)
DT-V9L5_EU_EN_1.indb 20 DT-V9L5_EU_EN_1.indb 20 10/10/2012 3:51:03 PM 10/10/2012 3:51:03 PM