26
1
REMOTE terminal
Terminal for controlling the monitor by an external control (
☞
“External Control” on page 40).
2
VIDEO terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
3
E. AUDIO HD/SD SDI (IN 1, IN 2) terminals (BNC)
Input terminals for the HD/SD SDI signals.
●
The terminals accept also EMBEDDED AUDIO signals including up to 16 audio channels with a sampling frequency of 48 kHz.
4
E. AUDIO HD/SD SDI (SWITCHED OUT) terminal (BNC)
Output terminal for the HD/SD SDI signals.
●
The SDI signals of the current input (SDI 1 or SDI 2) are re-clocked, then emitted.
●
When an input other than SDI 1 and SDI 2 is selected, the SDI signal of the input selected last time is emitted from this terminal.
●
The signals are emitted from this terminal only when the monitor is on or in “Power Save” (power save) mode(
☞
“No Sync Action” on
page 35).
5
HDMI terminal
Input terminal compatible with HDCP for the HDMI signal. (
☞
page 48)
6
COMPO./RGB terminal (mini D-sub 15pin)
Input terminal for the analog component signal or analog RGB signal. (
☞
page 48)
●
Set “Component/RGB Select” (
☞
page 33) appropriately for input signals.
7
AUDIO (IN) terminals (pin jack)
Input terminals for the analog audio signals.
●
Use this terminal for the analog audio connection of the SDI. When inputting audio into this terminal, set “SDI-1 Select” or “SDI-2 Select” of
the menu to “1ch+2ch”, “1ch” or “2ch” (
☞
page 34).
●
When you use HDMI input for the picture and analog sound for the audio signal, input analog sound into this terminal, and set “HDMI
Select” of the menu to “1ch+2ch”, “1ch” or “2ch” (
☞
page 34).
Rear panel
Index of Parts and Functionos
Security slot
Attach a security wire to this slot.
DT-E15L4̲EN.indb 26
DT-E15L4̲EN.indb 26
2012/11/01 17:10:45
2012/11/01 17:10:45
