(No.YD058)1-13
3.2.3 Remove the flexible wire assembly (See figure 6)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the four screws
G
and
H
attaching the flexible wire
assembly.
(2) Remove the solder part
c
soldered to the feed motor.
(3) Remove the two screws
I
attaching the shaft guide.
(4) Disconnect the flexible wire from connector
CN1
on the
spindle motor board.
Fig.6
3.2.4 Remove the servo control board and board bracket (See figure 7, figure 8)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the soler part
d
and
e
soldered on the servo con-
trol board.
(2) Disconnect the flexible wire from connector
CN301
on the
servo control board.
(3) Disconnect the card wire from connector
CN101
on the
servo control board.
(4) Remove the two screws
J
attaching the servo control
board.
(5) Remove the four screws
K
attaching the board bracket.
Fig.7
Fig.8
3.2.5 Remove the loading motor (See figure 7, figure 8)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the soler part
d
soldered on the servo control
board.
(2) A belt is removed.
(3) Remove the two screws
L
attaching the loading motor.
G
Part c
G
G
H
I
Flexible wire
assembly
Spindle motor assembly
CN1
Servo control board
CN301
CN101
Part d
J
Part e
J
K
K
K
L
Belt
