1-12 (No.YD058)
3.2.2 Remove the traverse mechanism assembly (See figure 3, figure 4, figure 5)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) It solder to part
b
section on the pick-up unit.
(2) Disconnect the card wire from connector
CN1
on the pick-
up unit.
ATTENTION:
Please extract the wire after short-circuited on the pick-
up unit in part
b
with solder. Please remove the solder of
part
b
after connecting the wire with
CN1
when reassem-
bling.
(3) Disconnect the flexible wire from connector
CN301
on the
servo control board.
(4) Remove the one screw
B
attaching the mechanism brack-
et.
(5) Remove the four screws
C
and
D
attaching the leaf spring.
(6) Remove the two screws
E
and
F
attaching the traverse
mechanism assembly.
(7) When a traverse mechanism assembly is in the lowest po-
sition, a gear 1 is turned clockwise, and since a traverse
mechanism assembly is moved to the upper position, it is
removed.
Fig.3
Fig.4
Fig.5
Pick-up unit
Part b
Traverse mechanism
assembly
Leaf spring
D
㧯
B
F
E
Pick-up unit
CN1
Mechanism
bracket
Servo control board
CN301
Traverse mechanism assembly
Gear 1
