
6
⁄
To connect the powered subwoofer
The connected subwoofer can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals encoded in multi-channel
software.
• Before plugging the System to the power supply, make
sure that the powered subwoofer is turned off.
@
TV/monitor
Connect either component cord or SCART cord.
• This connection allows you to use the progressive
scanning mode. To select progressive (“P-SCAN
YPBPR”) scanning mode (see page 15), use
COMPONENT VIDEO OUT jacks.
• This connection sends the video
signal (Composite, Y/C, or RGB)
and receives audio signal from TV.
To listen to the TV sound, see page
11.
• After connecting a TV, select the appropriate video
signal output according to the connection method. See
“Changing the Scanning Mode” on page 15.
P
B
COMPONENTVIDEO OUT
Y
P
R
From the powered subwoofer
(not supplied)
Green
Red
Blue
Component video cord
(not supplied)
On the front
panel
USB cable
(not supplied)
SUBWOOFER OUT
AV
SCART cord
(not supplied)
When connecting a USB mass storage class device
• When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m.
• You can connect a USB mass storage class device such as
a USB flash memory device, hard disk drive, multimedia
card reader, etc. to this System.
• You cannot connect a computer to the USB MEMORY
REC/PLAY terminal (
) of the System.
• You cannot connect JVC Everio camcorder to the USB
MEMORY REC/PLAY terminal (
) of the System.
• Noise and static electricity may stop the USB mass
storage class device sound. In this case, disconnect and
connect the USB mass storage class device again after
turning off the System.
• Depending on the shape of a USB mass storage class
device connected, you cannot open or close the disc tray
properly. In such a case, use a USB extension cable (not
supplied) to connect.
When connecting other equipment
Stereo mini plug
(not supplied)
On the front
panel
From audio output (or headphone out, etc.)