– 8 –
English
To audio output
Canceling the Display Demonstration
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration,
press
CANCEL/DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more
than 2 seconds.
AUX IN
Audio/video
equipment
Connecting Other Equipment
You can connect an audio equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
CANCEL
/ DEMO
CANCEL
/ DEMO
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screw driver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging the this unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
NOW, you can plug in the unit and other
connected equipment FINALLY!
S P E A K E R
[ ]
R
L
6-16
220
127
11
0
VOLTAGE
SETTING
230-
240
220
VOLTAGE
SETTING
127
240
11
0
230-
EN01-12.MX-K50[UW].pm6
02.5.16, 5:50 PM
8