JVC CA-MXK10R, Руководство по обслуживанию

Страница: 11 / 99

1-11
<Disassembly of units and assembly inside
this set>
n
Removing the CD PCB
(See Fig.13 and 14)
n
Prior to performing the following procedures, remove
the top cover and both sides board.
n
Also remove the CD changer unit.
1. Disconnect the wires from CN603A, CN603B and
CN604 on the CD PCB, which is located on the back
side of the CD changer unit.
2. The two screws "J" that retain the CD PCB should
be removed.
3. Remove the CD PCB by pulling it toward the side
where the CN601 is located.
4. Using solder, short the CD pickup to connect to short
round.
[Caution] After re-connecting the wires, be sure to
remove the shorting solder from the GND
connection.
5. Disconnect the card wire from the connector CN601
on the main PCB and then remove the main PCB.