3
English
Continued
Unpacking
After unpacking, check to be sure that you have all the following
items.
The number in the parentheses indicates the quantity of the pieces
supplied.
• AM loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)
• AC plug adaptor (except for Vietnam, Hong Kong and The
People's Republic of China: 1)
• Video cord (1)
If any is missing, consult your dealer immediately.
Putting the Batteries into the Remote Control
Insert the batteries — R6P(SUM-3)/AA(15F) — into the remote
control, by matching the polarity (+ and –) on the batteries with the
+ and – markings on the battery compartment.
When the remote control can no longer operate the unit, replace
both batteries at the same time.
2
R6P(SUM-3)/AA(15F)
3
1
• DO NOT use an old battery together with a
new one.
• DO NOT use different types of batteries
together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use
the remote control for an extended period of
time. Otherwise, it will be damaged from
battery leakage.
Connecting Antennas
FM antenna
FM
(75 )
ANTENNA
AM LOOP
FM
AM EXT
2
3
1
2
3
1
20 mm (13/16 in.)
10 mm
(7/16 in. )
Outdoor FM antenna
(not supplied)
FM antenna (supplied)
Extend the FM antenna (supplied) horizontally.
If reception is poor
Connect the outdoor antenna.
Before attaching a 75-ohm coaxial cable (the kind with a round
wire going to an outdoor antenna), disconnect the supplied FM
antenna.
How to strip the 75-ohm coaxial cable and connect it
to the FM terminals
1. Strip off the outside covering of the 75-ohm coaxial cable to
expose the braided metallic mesh about 20 mm (13/16
inches).
2. Pull the mesh back and twist it into a single connector as
shown in the illustration above.
3. Strip the insulation about 10 mm (7/16 inches) back from
the central wire.
4. Insert the twisted mesh and the central wire to the FM
terminals, as shown in the illustration above.
Getting Started
Getting Started
EN1-5;MX-J777V/PM6
7/8/99, 9:13 AM
3