JVC CA-MXG71R, Инструкция по эксплуатации

Страница: 12 / 43

– 9 –
Common Operations
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON
so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON
again so that the
STANDBY lamp lights up.
• The clock appears on the display (if
Ecology Mode is not activated).
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 12) will be erased in a few days.
Saving the Power Consumption While on
Standby — Ecology Mode
You can save the power consumption only while the unit is
turned off (on standby).
To activate the Ecology Mode, press ECO.
“ECO” appears and the display illumination
(including the display demonstration) disappears
from the display.
• Each time you press the button, “ECO” and
“NORMAL” appear alternately on the display.
To deactivate the Ecology Mode, press ECO again.
“NORMAL” appears and the display illumination appears on
the display.
About Ecology Mode
• You can also activate and deactivate Ecology Mode while the unit
is on, but it takes effect only when the unit is on standby.
• While Ecology Mode is activated, the display demonstration is
canceled temporarily.
DAILY
Canceled
ON TIME
ON TIME
Clock
setting
(The hour digits start flashing.)
REC
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the system is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn
4
/
¢
to adjust the
hour, then press SET/DISPLAY.
The minute digits start flashing on
the display.
• If you want to correct the
hour after pressing
SET/DISPLAY, press
CANCEL/DEMO.
The hour digits start flashing again.
3
Turn
4
/
¢
to adjust the
minute, then press SET/DISPLAY.
To check the clock time
Press and hold SET/DISPLAY while playing any source.
• Each time you press and hold the button, the source
indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
When you unplug the AC power cord or if a power
failure occurs
The clock loses the setting and is reset to “0:00.” You need to set the
clock again.
STANDBY/ON
STANDBY
STANDBY/ON
STANDBY
EN01-14.CA-MXGT91R&G71R[B]f 2/26/01, 6:56 PM 9