JVC CA-HXZ3, Инструкция по эксплуатации

Страница: 26 / 47

– 23 –
You can play back type I tapes without changing any settings.
Playing Back a Tape
1
Press
0
EJECT for the cassette deck.
2
Insert a cassette with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE
2 3
.
The tape play starts and the tape direction
indicator (
3
or
2
) starts flashing slowly
to indicate the tape running direction.
• Each time you press the button, the tape direction changes
and “REVERSE” appears for a while on the display.
3 3 3 3 3
: plays the front side.
2 2 2 2 2
: plays the reverse side.
• If no cassette is inserted, “NO TAPE” appears on the
display.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is off. (See “To play both sides
repeatedly—Reverse Mode.”)
To stop playing, press
7
.
To fast-wind to the left or to the right, press
1
or
¡
(or
4
(
1
) /
¢
(
¡
) on the remote control) while the tape
is not running.
The tape direction indicator (
3
or
2
) starts flashing quickly
on the display.
To remove the cassette, press
0
EJECT to open the cassette
holder.
Playing Back Tapes
To play both sides repeatedly—Reverse Mode
When using Reverse Mode, the tape automatically reverses at
the end of one side, starts playing the other side of the tape,
and repeats the same process.
On the unit ONLY:
To use Reverse Mode, press REVERSE MODE
so that the Reverse Mode indicator lights up on
the display like—
.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up on the display like— .
Locating the Beginning of a Song—Music Scan
You can use Music Scan to locate the beginning of a song.
Music Scan searches for blank portions that usually separate
recorded songs, then plays the next song.
To find the beginning of the current song
During play, press
1
or
¡
(or
4
(
1
) /
¢
(
¡
) on the
remote control) in the opposite
direction to the tape play.
The tape direction indicator of the
opposite direction to the tape play starts flashing intermittently.
Searching stops automatically at the beginning of the current
song, and it starts automatically.
To find the beginning of the next song
During play, press
1
or
¡
(or
4
(
1
) /
¢
(
¡
) on the
remote control) in the same direction
as the tape play.
The tape direction indicator of the
same direction as the tape play starts flashing intermittently.
Searching stops automatically at the beginning of the next
song, and it starts automatically.
Music Scan works by detecting a 4-second long blank
between each song, so it will not work well in the
following cases
• No blank at the beginning of a song.
• Noise (often caused by much use or poor quality dubbing) which
fills the blank.
• Long, very soft passages or pauses in a song.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
TAPE
REVERSE
MODE
EN16-23.CA-HXZ3R[B]f.p65 5/21/02, 2:09 PM 23