– 10 –
English
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at
low volume.
• This function only affects the playback sound, but does not
affect your recording.
To get the effect,
press AHB (Active Hyper Bass)
PRO until “AHB 1” or “AHB 2” appears on the
display. The BASS indicator also lights up on the
display.
• Each time you press the button, the bass sound
change as follows:
“AHB 2” has much more bass reinforcement effect than
“AHB 1.”
To cancel the effect,
press AHB PRO until “AHB OFF”
appears on the display and the BASS indicator goes off.
Selecting the Illumination Brightness
You can change the illumination brightness only while the
unit is turned on.
On the remote control ONLY:
To change the brightness,
press DIMMER.
• Each time you press the button, the illumination
dims and brightens alternately.
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between “VOL MIN”
and “VOLUME 1” – “VOLUME 40 (VOL MAX).”
When using the remote control,
press
to increase the volume or press
VOLUME – to decrease it.
When using the unit,
turn / –
clockwise (+) to increase the volume or
counterclockwise (–) to decrease it.
For private listening
Connect the headphones to the PHONES jack. No sound comes out
of the speakers. Be sure to turn down the volume before connecting
or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range) and the
treble level (high frequency range) within the range of –5 to
+5. Normally set these to 0 (initial setting at factory).
• This function only affects the playback sound, but does not
affect your recording.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Press BASS to adjust the bass level or press
TREBLE to adjust the treble level.
2
Press UP to increase the level or press DOWN
to decrease it.
VOLUME
VOLUME
+
–
BASS
AHB OFF
(Canceled)
AHB 1
AHB 2
DIMMER
TREBLE
BASS
BASS
TREBLE
UP
DOWN
UP
DOWN
AHB PRO
AHB PRO
EN01-12_FS-L30[C]f
02.2.13, 3:47 PM
10