JVC AV-20N3, Руководство по обслуживанию

Страница: 8 / 32

No. 52025
AV-20N3
AV-20NMG3
AV-20NMG3B
8
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Unplug the power plug.
2. As shown in figure, remove the
6
screws marked
!
! !
!
and a
screw marked
"
" "
"
.
3. Withdraw the rear cover toward you.
REMOVING THE MAIN PW BOARD
" After removing the rear cover.
1. Slightly raise the both sides of the MAIN PW BOARD by hand.
2. Withdraw the MAIN PW BOARD backward.
(If necess ary, take off the wire clamp, c onnectors etc.)
REMOVING THE SPEAKER
"
After removing the rear cover.
1. As shown in figure, remove the
2
screws marked
#
# #
#
.
2. Follow the s ame steps when removing the other hand speak er.
CHECKING THE MAIN PW BOARD
1. To check the back side of the PW Board.
1) Pull out the MAIN PW Board. (Refer to REMOVING THE MAIN
PW Board)
2) Erect the PW Board vertic ally so that you can easily check the
back side of the PW Board.
[CAUTION]
" When erecting the PW Board, be careful s o that there will be no
contacting with other PW Board.
" Before turning on power, make sure that the CRT earth wire and
other connector are properly c onnected.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire.
2. Never remove the c able tie used for tying the wires together.
Should it be inadvertently removed, be sure to tie the wires with a
new cable tie.