No. 56091
AV-14AM
6
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Unplug the power plug.
2. As shown in figure, remove the
5
screws marked
A
A
A
A
and
a
screw marked
B
B
B
B
.
3. Withdraw the rear cover toward you.
REMOVING THE MAIN PW BOARD
"
After removing the rear cover.
1. Slightly raise the both sides of the MAIN PW BOARD by hand
and remove the PWB stopper marked
c
c
c
c
from the front
cabinet.
2. Withdraw the MAIN PW BOARD backward.
(If necessary, take off the wire clamp, connectors etc.)
REMOVING THE SPEAKER
"
After removing the rear cover.
1. By holding up the SPEAKER HOLDER slightly and unlocking
the claw (marked
D
D
D
D
). Then SPEAKER HOLDER can be
removed.
2. Then you can remove the SPEAKER.
CHECKING THE MAIN PW BOARD
1. To check the PW Board from back side.
1) Pull out the MAIN PW Board. (Refer to REMOVING THE
MAIN PW Board)
2) Erect the PW Board vertically so that you can easily check
the back side of the PW Board.
[CAUTION]
"
When erecting the PW Board, be careful so that there will be
no contacting with other PW Board.
"
Before turning on power, make sure that the CRT earth wire
and other connector are properly connected.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire.
2. Never remove the cable tie used for tying the wires together.
Should it be inadvertently removed, be sure to tie the wires
with a new cable tie.
