jurop VL 14, Инструкция по установке, использованию и техническому обслуживанию, Страница: 14 / 28

the bearing and press it to the correct position.
NOTE: The outside circular groove on the bearing bushing
of pos. 9 must match exactly the plane of the outside face
of the bearing flange of pos. 4.
If this does not occur, pos. 6-23-22-9 must be disassembled
and checked.
h- Insert the spacer of pos. 29.
i- Screw on the ring M45x1,5 by means of the spanner UNI 6752
and tighten it with a torque of 350 Nm.
The selflocking ring can be re-used a second time.
l- Bend the tab of the safety ring of pos. 29 by means of a punch
in order to block the selflocking ring.
m- Check the seal of pos. 27 and replace it if it is weared.
Fill with grease the flange of pos. 5 and screw on the n. 3 screws
of pos. 38.
12
Fig. 15
Fig. 15.g
29
28
38
5
27
9
22
23
6
25
38
48
42
4
16+3
35
14
9
4
Screw on the n. 8 screw of pos. 42.
c- Insert the bushing of pos. 25 on the axle and take it to the correct
position by means of the introduction pipe diam. 55x47 of a
suitable length (lubricate thoroughly the inside and outside of
the bushing).
d- Insert the spacer of pos. 6, checking that it is correctly centered.
e- Insert the protection screen of pos. 23.
f- Insert the bearing of pos. 22 on the axle and by means of the
introduction pipe of point “c” and of a hammer bring it to the
correct position.
g- Center the bearing bushing of pos. 9 to the outside diameter of
6.2.2.8 Assemble of the front end plate-housing of VL 7-14-
20-27
Check that the two O-rings of the seals housing and the O-rings of
the axle are in the correct position.
a- Insert the flange of pos. 4 on the pump housing and screw on
the n. 6 screws of pos. 38.
b- Insert the housing gasket of pos. 14 in between the wearplate
of pos. 16+3 and the pump housing.
Set together the wearplate and the end plate and pin them by
means of the n. 4 pins of pos. 35.