![Jupiter Avionics JA95-043 Скачать руководство пользователя страница 12](http://html.mh-extra.com/html/jupiter-avionics/ja95-043/ja95-043_installation-and-operating-manual_2033793012.webp)
JA95-043 Audio Controller - AMS43 Compatible
Installation and Operating Manual
Rev B
Page 8
e) Plug in the co-pilot’s headset. Check for correct ICS operation. Check yoke or cyclic switch functions.
f) Plug in any remaining headsets, and check for correct ICS operation. Note that an incorrect cordset (drop cord)
or improper jack wiring may cause a wide range of problems, from loss of audio to a tone heard in the headset.
g) Check that all configurations settings are correct.
When all performance checks are satisfied, complete the necessary regulatory documentation before releasing the
aircraft for service. Refer to
Appendix B.
2.5
Adjustments and Configuration using ProCS™
All the JA95-043 internal adjustments are set from the
Product Configuration Software ProCS™
. Configuration data is
sent to the JA95-043 via the front panel connector (
♫
/io), using the Configuration Cables and a computer running the
ProCS™ software. For configuration requirements, see section 2.5.1.
For full information on the configuration process, and for installation of ProCS™ on your computer, refer to the
ProCS™ manual
on the Jupiter Avionics website -
www.jupiteravionics.com/productsoftware.
2.5.1
Configuration Cabling Requirements
To configure the JA95-043, it is necessary to load the
Product Configuration Software ProCS™
onto a Windows-
based computer as described in the
ProCS™ manual
.
The cables required to configure the JA95-043 are not included with the unit.
Cabling option 1:
Quantity
Description
JAC Part #
1
USB A to RS232 9-Pin Cable
CAB-USB-0002
1
Configuration Cable
JA99-001
Cabling option 2:
Quantity
Description
JAC Part #
1
USB A Male to RS232 3.5mm Plug
CAB-USB-0006
2.5.2
ProCS™ Setup
The ProCS™ JA95-043 menu item 'ProCS Setup' provides drawings showing the cabling arrangement for
connecting the JA95-043 to a computer running the ProCS™.
2.5.3
Configurable Settings
A standard unit is shipped from the factory with all internal adjustments configured to the default levels. At installation,
it may be desirable to change some of these settings to suit the local operating environment.
Note
: To properly configure the JA95-043, power must be applied to the unit.
Within ProCS™, the configurable settings are grouped together into the following sections: