IMPORTANT SAFETY INSTRUCTIONS:
When using electrical equipment, always adhere to basic safety precautions
including the following:
TL601E-10 12 volt, 0.5W min. – 10W max.
TL601E-25 12 volt, 0.5W min. – 25W max.
TL601E-60 12 volt, 0.5W min. – 60W max.
TL601E-XX 12 volt, 0.5W min. – XXW max.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
For JUNO TL601E SERIES SURFACE TRANSFORMERS
1.
Read and save all instructions.
2.
Do not install this system in wet locations.
3.
Do not install any fixture assembly closer
than 6 inches from any curtain or similar
combustible material.
4.
Reference local electrical/building codes for
approved wiring techniques.
5.
For use with Juno Trac 12 and DanaLite
low voltage lighting systems only.
6.
Do not conceal or extend exposed
conductors through a building wall.
7.
To reduce the risk of fire and burns, do not
install this lighting system where the
exposed bare conductors can be shorted
or contact any conductive materials.
8.
To reduce the risk of fire and overheating,
make sure all connections are tight.
9.
Turn off electrical power before modifying
the lighting system in any way.
INSTALLATION INSTRUCTIONS
NOTE: If installing transformer with cord
and plug (TL601E-XX-CP6), skip steps 5-8
and ignore Figure 2.
1.
(Fig. 1) Remove cover and mount
transformer assembly near the end of the
trac using 2 wood screws provided.
2.
Remove trac end feed cover and detach
breakout tab.
3.
Cut and strip red transformer secondary
wires as needed. Strip no more than 3/8"
from end of wire.
4.
Insert secondary (red) wires into terminals
in trac end feed connector. Tighten set
screws to a torque of 7in-lb minimum.
5.
(Fig. 2) Attach 120 Volt supply to open end
of bracket with 1/2" conduit fitting provided.
6.
Insert line voltage wire into terminal marked
“L”. Tighten set screw to a torque of 7in-lb
minimum.
7.
Insert neutral wire into terminal marked “N”.
Tighten set screw to a torque of 7in-lb
minimum.
8.
Insert ground wire under and around green
ground screw and tighten.
9.
Reinstall end feed cover and transformer
cover.
© 2008 Juno Rev 06/08 P2471 pg 1 of 1
WARRANTY
Juno Lighting Group warrants that its products are free from defects in material and workmanship. Juno Lighting Group’s obligation
is expressly limited to repair or replacement, without charge, at Juno Lighting Group’s factory after prior written return authorization has been
granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting Group’s factory. This warranty
is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes any implied warranty
of merchantability. Also, there are no warranties which extend beyond the description of the product on the company’s literature setting forth
terms of sale.
Product Services Phone (888) 387-2212
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
Fig. 1
Fig. 2
