10
Gerät in die Nische einschieben bis die
Anschlagleiste (A) unten am Möbel anliegt.
A
D023
Montageanleitung für den
integrierten Einbau
Nischenmaße
Höhe
1780 mm
Tiefe
550 mm
Breite
560 mm
Aus Gründen der Sicherheit muß eine
Mindestbelüftung gesichert sein, wie aus der
Abb.hervorgeht.
Achtung: Die Ventilations - Öffnungen müssen
immer saubergehalten werden.
Ferner ist auch am hinteren Einbauschrankteil ein
Lüftungskamin mit filgenden Massen notwendig:
Tiefe
50 mm
Breite
540 mm
50 mm
min.
200 cm
2
200 cm
2
min.
D567
PR01
540
50
B
T H
Fugenabdeckprofil am Gerät, wie in Abbildung
gezeigt ankleben.
D765
5. Untere Scharnierstift abschrauben und
Kunstoffteil entfernen und auf gegenüberliegende
Seite wieder anmontieren
15
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with luke-warm
water and some neutral soap so as to remove the
typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage the finish.
Operation
Insert the plug into the wall socket.
Open the refrigerator door and turn the thermostat
knob, clockwise, beyond the «O» (STOP) position.
The appliance will start to operate.To stop
operation, simply turn the thermostat knob to
position «O»
Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
•
room temperature;
•
how often the door is opened;
•
the quantity of food stored;
•
location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
USE
Freezing fresh food
The 4-star compartment is suitable for long term
storage of commercially frozen food and for freezing
fresh food.
To freeze fresh foods it is not necessary to move the
thermostat knob from the normal setting.However,
for a faster freezing operation, turn the termostat
knob to the coldest setting; but remember that, in
this condition, the refrigerator compartment
temperature might drop below 0°C.If this oocurs
reset the thermostat knob to a warmer setting.
Place the food to be frozen in the upper in the
freezer compartment as this is the coldest part.
Fresh food refrigeration
To obtain the best performance:
•
do not store warm food or evaporating liquids in
the refrigerator;
•
do cover or wrap the food, particularly if it has a
strong flavour.
•
Position food so that air can circulate freely round it.
Storage of frozen food
When first starting-up or after a period out of use,
before putting the products in the compartment let
the appliance run for at least two hours on the
coldest setting, then turn the thermostat knob to the
normal operating position.
Important
If there is a power failure when food is in the
freezer, do not open the door of the freezer
compartment. The frozen food will not be
affected if the power cut is of short duration (up
to 6-8 hours) and the freezer compartment is full,
otherwise, it is recommended that the food
should be used within a short time (a
temperature increase of the frozen food shortens
its safe storage period).
Thawing
Deep-frozen or frozen food, prior to being used, can
be thawed in the refrigerator compartment or at
room temperature, depending on the time available
for this operation.
Small pieces may even be cooked still frozen, directly
from the freezer: in this case, cooking will take longer.
Ice-cube production
This appliance is equipped with one or more trays
for the production of ice-cubes.Fill these trays with
water, then put them in the freezer compartment.
Do not use metallic instruments to remove the
trays from the freezer.
