JUNO JH084C1, Руководство пользователя

Страница: 5 / 24

Ventilation opening mini‐
mum size. Opening
placed on the bottom
rear side 560x20 mm
Mounting screws 4x25 mm
Before you install the appliance, fit it with the
applicable hob from the table.
Type Maximum power
JKFN604F5 6000 W
JKFN606F5 7600 W
2.2 Electrical connection
WARNING!
Risk of fire and electric shock.
• All electrical connections should be made
by a qualified electrician.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable. Should
the mains cable need to be replaced, this
must be carried out by our Authorised
Service Centre.
• Do not let mains cables touch or come
near the appliance door or the niche below
the appliance, especially when it operates
or the door is hot.
• The shock protection of live and insulated
parts must be fastened in such a way that
it cannot be removed without tools.
• Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.
• If the mains socket is loose, do not
connect the mains plug.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
• The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.
• This appliance is supplied without a main
plug and a main cable.
• The hob connection socket is at the top of
the oven cabinet. The hob has connection
leads for the cooking zones and the
ground cable. The leads have plug-in
connectors. Plug the connectors into the
correct oven socket to connect the hob to
the oven. The design of the plugs and
sockets prevents incorrect connections.
If the mains voltage is different, rearrange the
jumpers on the terminal board (refer to the
connection diagram below). Connect the
ground cable to the terminal. After you
connect the supply cable to the terminal
board, attach it with a junction clamp.
Connecting to terminal board
The appliance has a six-pole terminal board. The
jumpers (bridges) are set for operation on a 400 V
three-phase with a neutral wire.
1 = 45 mm
2 = 45 mm
3 = 60 mm
4 = 60 mm
= 70 mm
1 2 3
4
L 1 – 2 – 3 = phase cables
N 4 = neutral cable
= earth cable
3
5
6
6
1
8
7
3
9
230V ~
230V ~
1 2 3
5 4
2N ~
230V ~
1 2 3
5 4
3N ~
230V ~
1 2 3
5 4
ENGLISH 5