11
press button A and button H at the same time
for about two seconds until you hear the acoustic
signal (beep): the grease filter saturation led F
will now stop flashing.
To remove the metal grease filter - Fig. 2, F:
To dismount the filter , push it backwards and
then downwards.
Carry out the above steps in reverse order to
put the filters back after having washed them.
Carbon filter
(“recirculation mode only”, see next pages)
The carbon filter cannot be washed nor
regenerated.
Hood featuring control panel with keypad
The carbon filter should be replaced every 6
months under normal use.
Hood with electronic control panel
The carbon filter should be replaced every 6
months under normal use and anyhow
whenever the carbon filter saturation led
indicates the saturation of the filter.
This LED indicates carbon filter needs to be
replaced.
This led flashes to warn you that the carbon
filter must be replaced.
This must be done after approximately 160
hours of use.
Once you have replaced the carbon filter, press
button A and button B together for about two
seconds (see page 10) until you hear the
acoustic signal (beep).
The carbon filter saturation led C will now stop
flashing.
N.B.: the carbon filter saturation led will also
flash even if the hood is used in the exhausting
version (i.e. without carbon filter).
To stop the led flashing, press the two buttons
A and B as described above.
To fit the carbon filter - Fig. 3:
1. Remove the metal grease filters.
2. Fit the carbon filter into its housing, by
pushing it backwards and then forwards
and fixing it with the two red buttons B on
the carbon filter.
3. Put the metal grease filter back into place.
To remove the carbon filter - Fig. 3:
To dismount the carbon filter, press the two
buttons B and pull downwards .
GB
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Attention
Failure to observe the instructions for cleaning
the appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp
- Fig. 6,M
— Unplug the appliance from the mains
— Remove the burnt lamp.
— Use only 20 W (max) halogen lamps.
— Fit the new lamp ensuring that the two male
contacts of the lamp fit perfectly into the
female contacts of the lamp holder.
— If the lighting is not operating, remember to
check that the lamps are fitted correctly
before calling your technician.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy sources
other than electricity.
— When the hood is used at the same time of
other appliances that run on energy sources
other than electricity, provision must be
made for an adequate supply of air.
— No food must be cooked flambé underneath
the hood.
The use of an unprotected flame is
dangerous for the filters and could cause
fires.
Therefore, never use an open flame under
the hood. When frying foods, never leave
the pan alone because the cooking oil could
flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or its
catching on fire because of failure to observe
the above instructions.
— A constant maintenance guarantees a good
Содержание JDK9940S
Страница 3: ......
