10
Filter saturation control devices for
grease filters
This hood is supplied with a device that
notifies the user when the grease filter must
be cleaned or the carbon filter replaced (if
installed).
Upon installation, the saturation control
device for the carbon filter is not activated
(the hood is ready for use in vent mode).
In the event, you would like to install a
carbon filter, activate the saturation control
device by pressing the B and G buttons at
the same time for 3 seconds.
O
1
2
3
F
C
at the start of this procedure, only the F Led
will blink, after 3 seconds have passed, the
C Led will begin to blink, as well to indicate
that the saturation control device for the
carbon filter has been activated.
Grease filter saturation Led
1
2
3
F
C
The Led marked F flashes to warn you when
the grease filter needs to be cleaned.
Carbon filter saturation Led
1
2
3
F
C
The Led marked C flashes to indicate carbon
filter needs to be replaced.
Reset for the saturation control
devices for grease and carbon filters
Once the grease filters have been cleaned
or the carbon filter replaced, press the A
button for approximately 3 seconds until
you hear the (beep):
O
1
2
3
F
C
The F led and C led (if active) will stop
blinking.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter -
Fig. 2
The cooker hood is fitted with metal filters.
Remove the metal filter using the handles
designed for this purpose by pulling them
backwards and then downwards.
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at
least once a month.
Before refitting the filter ensure that it is
perfectly dry.
Position of filters is interchangeable.
ATTENTION! The metal grease filter might
discolours when washed in the dishwasher.
Carbon filter -
Fig. 3
This filter dissolves cooking odours.
The carbon filter must never be washed.
It should be changed every 4 months in
normal use.
Fitting the carbon filter
Fit the carbon filter into its housing, by
pushing it backwards and then forwards
and fixing it with the two red buttons B on
the carbon filter.
