JUNO JCN10210S5, Руководство пользователя

Страница: 21 / 52

Problem Possible cause Solution
Water flows on the rear plate
of the refrigerator. During the automatic de-
frosting process, frost
melts on the rear plate. This is correct.
Water flows inside the refrig-
erator. The water outlet is clog-
ged. Clean the water outlet.
Food products prevent that
water flows into the water
collector. Make sure that food products
do not touch the rear plate.
The temperature in the appli-
ance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower temperature.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products tempera-
ture decrease to room temper-
ature before storage.
Many food products are
stored at the same time. Store less food products at the
same time.
The door has been opened
often. Open the door only if necessa-
ry.
There is no cold air circula-
tion in the appliance. Make sure that there is cold air
circulation in the appliance.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
3. Replace the used lamp with a new lamp
of the same power and specifically
designed for household appliances (the
maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
21