Junker JD66BW50, Инструкция по установке и эксплуатации

Страница: 21 / 44

21
Installation
1.
Attaching and aligning the appliance. ¨
2.
Mark the hole for the safety screw. ©
3.
Remove the appliance once more. ª
Finishing installation of the appliance
1.
Drill an 8mm Øhole to a depth of 80mm for the safety screw
and press the wall plug flush into the wall.
¨
2.
First remove the protective foil from the back of the appliance
and, following installation, remove the foil completely.
3.
Connect the appliance.
©
4.
Screw in the safety screw - and washer - and tighten all the
screws.
ª
Connecting the appliance to the power supply
Connecting the air extractor
Note:
If using an aluminium pipe, smooth the connection area
beforehand.
1.
Attach the air extractor pipe directly to the air-pipe connector.
2.
Connect to air extractor opening.
3.
Seal the joints appropriately.
Connect the power supply
1.
Plug the mains plug into the earthed socket.
2.
If a fixed connection is required, please follow the instructions
in the Electrical Connection section.
Attaching the flue duct
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
1.
Separate the flue ducts.
To do this, remove the adhesive tape.
2.
Remove the protective foil from both flue ducts.
3.
Push one flue duct into the other.
Notes
■
To prevent scratches, lay paper over the edges of the lower
flue duct to protect the surface.
■
The slots of the inner flue duct point downwards.
4.
Place flue ducts on the appliance.
5.
Push the inner flue duct upwards and attach it to the fixing
brackets on the left and right.
¨
6.
Press the flue duct downwards until it engages.
©
7.
Screw the flue duct to the sides of the fixing bracket using
two screws.
ª
$
%
&
$
%
&
[
$
%
&