Juniper XRE200 -, Руководство по оборудованию

Страница: 83 / 188

SEE ALSO
DC Power Supply in an XRE200 External Routing Engine | 38
Connecting the XRE200 to Management Devices
IN THIS SECTION
Connect a Device to a Network for Out-of-Band Management | 83
Connecting an EX8200 Switch to an XRE200 External Routing Engine | 84
Connect a Device to a Management Console Using an RJ-45 Connector | 86
Connect a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end. Figure 26 on page 83
shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 26: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see Figure 27 on page 84 ):
1. Connect one end of the Ethernet cable to the management port on the device.
2. Connect the other end of the Ethernet cable to the management device.
83