Juniper TCX1000-RDM20, Руководство по оборудованию

Страница: 145 / 206

2.
Remove the TCX1000-RDM20 from the rack.
3.
Transport the TCX1000-RDM20 to your desired new location or pack it to prepare to
return (see
“Returning a Hardware Component to Juniper Networks, Inc.” on page 145 ).
Related
Documentation
Mounting a TCX1000-RDM20 in a Rack or Cabinet on page 62
•
Removing a TCX1000-2D8CMD from a Rack
If you need to remove a TCX1000-2D8CMD to return it or relocate an installed
TCX1000-2D8CMD, perform the following procedure.
NOTE: When you remove multiple devices from a rack, remove the device in
the top of the rack first and proceed to remove the rest of the devices from
top to bottom to avoid toppling the rack.
NOTE: This procedure requires two persons. Do not attempt to do it alone.
Before removing a TCX1000-2D8CMD from a rack:
• Ensure that the rack is stable and secured to the building.
• Ensure that there is enough space to place the removed TCX1000-2D8CMD in its new
location and along the path to the new location.
•
Read “General Electrical Safety Guidelines and Warnings” on page 177 , and “Installation
Instructions Warning” on page 159 .
• Ensure that you have disconnected any cables or wires attached to the
TCX1000-RDM20 (see
“Disconnecting a Fiber-Optic Cable from a TCX1000 Device”
on page 125 ).
• Ensure that you have disconnected any cables or wires attached to the eight channel
ports (C0 to C7 ports) on the TCX1000-2D8CMD (see
“Disconnecting a Fiber-Optic
Cable from a TCX1000 Device” on page 125 ).
Ensure that you have the following tool available:
•
Screwdriver appropriate for your rack-mounting screws.
To remove a TCX1000-2D8CMD from a rack:
131 Copyright © 2019, Juniper Networks, Inc.
Chapter 22: Removing the Device