Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 10 / 60

SSG 140 Series Hardware Installation and Configuration Guide
10 „
Front Panel
Port Descriptions
Table 1 describes the function, connector type, and speed/protocol (if applicable) of
the ports on the front panel of the SSG 140 device.
Table 1: SSG 140 Ports
Item Description Connector Speed/Protocol
Ethernet 0/0 to
0/7 Ports Enables ethernet connections to workstations or a LAN connection
through a switch or hub. These connections also allow you to manage
the device through a Telnet session or the WebUI.
When configuring one of the ports, reference the interface name that
corresponds to the location of the port. From left to right on the front
panel, the interface names for the ports are
ethernet0/0 through
ethernet0/9 . For the default zone bindings for each Ethernet port, see
“Default Device Settings” on page 25.
RJ-45 10/100 Mbps
Ethernet
Autosensing duplex
and auto MDI/MDIX
Ethernet 0/8 to
0/9 Ports Enables ethernet connections to workstations or a LAN connection
through a switch or hub. These connections also allow you to manage
the device through a Telnet session or the WebUI.
When configuring one of the ports, reference the interface name that
corresponds to the location of the port. From left to right on the front
panel, the interface names for the ports are
ethernet0/0 through
ethernet0/9 . For the default zone bindings for each Ethernet port, see
“Default Device Settings” on page 25.
RJ-45 10/100/1000 Mbps
Ethernet
Autosensing duplex
and auto MDI/MDIX
USB Port Enables a 1.1 USB connection with the device. See “USB Port” on
page 12 for more information. - 12M (full speed) or
1.5M (low speed)
Console Port The console port is an RJ-45 serial data terminal equipment (DTE) port
that can be used for either local or remote administration. For local
administration, connect the port to a terminal with an RJ-45-to-DB-9
(female-to-male) straight-through serial cable. For remote
administration, connect the port to a workstation with an RJ-45-to-DB-9
(female-to-male) serial cable with a null modem adapter.
See “Connectors” on page 48 for the RJ-45 connector pinouts.
RJ-45 9600 bps/RS-232C
serial
AUX Port The auxiliary (AUX) port is an RJ-45 serial port wired as a DTE that you
can connect to a modem to allow remote administration. We do not
recommend using this port for regular remote administration. The AUX
port is typically assigned to be the backup serial interface. The baud
rate is adjustable from 9600 bps to 115200 bps and requires hardware
flow control.
See “Connectors” on page 48 for the RJ-45 connector pinouts.
RJ-45 9600 bps — 115
Kbps/RS-232C serial