Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 25 / 60

Default Device Settings
„ 25
Chapter 3: Configuring the Device
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To prevent the console from timing out and
terminating automatically, enter
set console timeout 0
.
Default Device Settings
Table 4 describes the default interface-to-zone bindings on the SSG 140 device.
Table 4: Default Interface-to-Zone Bindings
Note that the ethernet0/0 interface has the default IP address 192.168.1.1/24 and is
configured for management services. If you connect the 0/0 port on the SSG 140
device to a workstation, you can configure the device from a workstation in the
192.168.1.1/24 subnetwork using a management service such as Telnet. You can
change the default IP address on the ethernet0/0 interface to match the addresses
on your LAN.
The SSG 140 comes preconfigured with three bridge group (bgroup) interfaces
numbered bgroup0/0 through bgroup0/2. Bgroups let you group multiple Ethernet
interfaces together. Each bgroup constitutes its own broadcast domain and provides
high-speed Ethernet switching between interfaces within the group. You can assign
a single IP address to each bgroup interface. You can bind a bgroup interface to any
zone.
Port Label Interface Zone
10/100 Ethernet ports:
0/0 (default IP address is 192.168.1.1/24) ethernet0/0 Trust
0/1 ethernet0/1 DMZ
0/2 ethernet0/2 Untrust
0/3 ethernet0/3 Null
0/4 ethernet0/4 Null
0/5 ethernet0/5 Null
0/6 ethernet0/6 Null
0/7 ethernet0/7 Null
10/100/1000 Gigabit Ethernet ports:
0/8 ethernet0/8 Null
0/9 ethernet0/9 Null