Juniper SRX5600, Руководство по оборудованию

Страница: 332 / 483

Figure 137: Removing a Port Module
g030273
10. If you are not reinstalling a port module into the empty slot within a short time, install a blank panel
over the slot to maintain proper airflow in the card cage.
CAUTION: After removing a port module from the chassis, wait at least 30
seconds before reinserting it, removing a port module from a different slot, or
inserting a port module into a different slot.
Installing an SRX5600 Services Gateway Port Module
To install a port module into a Flex IOC (see Figure 138 on page 336 ):
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Power off the services gateway.
3. If you have not already done so, install the Flex IOC in which you are installing the port module.
4. Place the port module on an antistatic mat or remove it from its electrostatic bag.
5. Verify that each fiber-optic transceiver is covered with a rubber safety cap. If it is not, cover the
transceiver with a safety cap.
6. If necessary, remove the blank panel covering the slot in the Flex IOC where you are installing the port
module.
335