Juniper SRX5400, Руководство по оборудованию

Страница: 279 / 394

connect it to the
AUX
port on the Routing Engine. Both ports accept a cable with an RJ-45
connector. One RJ-45/DB-9 cable is provided with the services gateway. If you want to
connect a device to both ports, you must supply another cable.
To replace a cable connected to a management console or auxiliary device:
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Press the tab on the connector and pull the connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
Plug the RJ-45 end of the replacement serial cable into the
CONSOLE
or
AUX
port.
Figure 104 on page 253 shows the external device ports on the Routing Engine.
5.
Plug the female DB-9 end into the console or auxiliary device's serial port.
Figure 104: Auxiliary and Console Ports
Related
Documentation
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway
•
•
Replacing the SRX5400 Services Gateway Routing Engine on page 276
•
Replacing the Management Ethernet Cable on the SRX5400 Services Gateway on
page 252
Replacing an SRX5400 Services Gateway Network Cable
• Removing an SRX5400 Services Gateway Network Cable on page 253
• Installing an SRX5400 Services Gateway Network Cable on page 254
Removing an SRX5400 Services Gateway Network Cable
Removing and installing network cables does not affect services gateway function, except
that the component does not receive or transmit data while its cable is disconnected.
To remove a fiber-optic cable from a MIC:
1.
If the component connects to fiber-optic cable, have ready a rubber safety cap for
each cable and transceiver.
2.
If removing all cables connected to a MIC, use one of the following methods to take
the MIC offline:
253 Copyright © 2017, Juniper Networks, Inc.
Chapter 27: Replacing Cables and Connectors