Juniper SRX5400, Руководство по оборудованию

Страница: 276 / 394

Figure 98: Alarm Relay Contacts
Removing the SRX5400 Services Gateway Craft Interface
To remove the craft interface (see Figure 99 on page 250 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Detach any external devices connected to the craft interface.
3.
Loosen the captive screws at the top left and right corners of the craft interface
faceplate.
4.
Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
5.
Disconnect the ribbon cable from the back of the faceplate by gently pressing on both
sides of the latch with your thumb and forefinger. Remove the craft interface from
the chassis.
Figure 99: Removing the Craft Interface
g030339
Captive Screws
Installing the SRX5400 Services Gateway Craft Interface
To install the craft interface (see Figure 86 on page 178 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Grasp the craft interface with one hand and hold the bottom edge of the craft interface
with the other hand to support its weight.
3.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
keyed and can be inserted only one way.
Copyright © 2017, Juniper Networks, Inc. 250
SRX5400 Services Gateway Hardware Guide