Juniper SRX4100, Руководство по оборудованию

Страница: 22 / 134

Table 3: SRX4100 Services Gateway Components on the Front
Panel
(continued)
Description Component Number
Connects a laptop to the services gateway for CLI
management. The port uses an RJ-45 serial connection, is
configured as DTE, and supports the RS-232 (EIA-232)
standard. Console port 6
Returns the services gateway to the factory-default
configuration. Reset button 7
Chassis Status LEDs
Figure 2 on page 6 shows the LEDs on the front panel, and Table 4 on page 6 describes
the LEDs.
Figure 2: SRX4100 Services Gateway Front Panel LEDs
g005228
Power
Status
SSD
Table 4: SRX4100 Services Gateway Front Panel LEDs
Description LED
• Solid green—receiving power Power
• Solid green—operating normally
• Solid red—critical alarm
• Hardware component failure
• Software module failure
• Fan failure (atleast one)
• Blinking red—noncritical alarm
• The other HA node is in the lost, disabled, or ineligible state.
• Off—the system is not receiving power
Status
• Blinking green—indicates hard disk drive (SSD) activity SSD
Management Port LEDs
The management port has two LEDs that indicate link activity and status of the
management port.
Table 5 on page 7 describes the LEDs.
Copyright © 2017, Juniper Networks, Inc. 6
SRX4100 Services Gateway Hardware Guide