Juniper SRX240 Series, Руководство по оборудованию, Страница: 112 / 198

}
}
}
}
vlans {
vlan-trust {
vlan-id 3;
l3-interface vlan.0;
}
}
protocols {
stp;
}
Related
Documentation
SRX240 Services Gateway Software Configuration Overview on page 79
•
•
SRX240 Services Gateway Autoinstallation Overview on page 49
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 94
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface on page 97
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI
This procedure connects the services gateway to the network but does not enable it to
forward traffic. For complete information about enabling the services gateway to forward
traffic, including examples, see the appropriate Junos OS configuration guides.
To configure the software:
1.
Verify that the services gateway is powered on.
2.
Log in as the root user. There is no password.
3.
Start the CLI:
root# cli
root@>
4.
Enter configuration mode:
configure
[edit]
root@#
5.
Set the root authentication password by entering a cleartext password, an encrypted
password, or an SSH public key string (DSA or RSA):
[edit]
root@#
set system root-authentication plain-text-password
New password: password
Retype new password: password
Copyright © 2015, Juniper Networks, Inc. 94
SRX240 Services Gateway Hardware Guide