Juniper SRX240 Series, Руководство по оборудованию

Страница: 115 / 198

admin@host# exit
admin@host>
Related
Documentation
Connecting the SRX240 Services Gateway to the CLI on page 85
•
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
Setup Wizard
•
SRX240 Services Gateway Software Configuration Overview on page 79
•
SRX240 Services Gateway Secure Web Access Overview on page 84
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface
This topic describes how to perform the initial configuration of your services gateway
using the J-Web setup wizard that is available in Junos OS Release 11.2R2 or earlier. If
your services gateway is running Release 11.2R3 or later, see
Performing Initial Software
Configuration on the SRX240 Services Gateway Using the Setup Wizard .
This topic includes the following sections:
• Establishing Basic Connectivity on page 97
•
Configuring Basic System Properties on page 98
Establishing Basic Connectivity
To establish basic connectivity:
1.
Connect an Ethernet cable from any of the ports 0/1 through 0/15 to the Ethernet port
on the management device (workstation or laptop).
2.
Connect the power cable to the device and a power source. (We recommend using
a surge protector.) Note the following indications:
•
Power LED (steadily green): The device is receiving power.
•
Status LED (steadily green): The device is operating normally.
NOTE: The services gateway functions as a DHCP server and will assign
an IP address to the management device.
3.
Ensure that the management device acquires an IP address on the 192.168.1.0/24
subnetwork (other than 192.168.1.1) from the device.
NOTE: If an IP address is not assigned to the management device,
manually configure an IP address in the 192.168.1.0/24 subnetwork. Do
not assign the 192.168.1.1 IP address to the management device, as this IP
address is assigned to the services gateway.
97 Copyright © 2015, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration