Juniper SRX220, Руководство по оборудованию

Страница: 127 / 182

Monitoring the SRX220 Services Gateway Using Chassis Alarm Conditions
When the services gateway detects an alarm condition, the Alarm LED on the front panel
turns red or amber as appropriate.
To view a more detailed description of the cause of the alarm, issue the show chassis
alarms command on the command-line interface (CLI).
For more information on the show chassis alarms command, see the
Initial Configuration
for Security Devices
.
Table 40 on page 109 describes alarms that can occur for an SRX220 Services Gateway
chassis component.
Table 40: SRX220 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Alarm
Severity
Action Alarm Condition Component
Amber (minor) • If the CompactFlash card fails at
startup, the services gateway
automatically boots from the
alternative boot device (USB storage
device).
NOTE: If you configured your
services gateway to boot from an
alternative boot device, ignore this
alarm condition.
•
Reformat the CompactFlash card,
and install a bootable image. (See
the
Initial Configuration for
Security Devices
.)
•
If you did not configure the services
gateway to boot from an alternative
boot device, contact Juniper
Networks Technical Assistance
Center (JTAC). See
“Juniper
Networks Technical Assistance
Center” on page 113
.
The services gateway
boots from an alternate
boot device. Boot
media
Red (major) • Contact the Juniper Networks
Technical Assistance Center (JTAC).
See
“Juniper Networks Technical
Assistance Center” on page 113 .
• If you must replace the failed
Mini-PIM, see the
SRX Series
Services Gateways for the Branch
Physical Interface Modules
Hardware Guide
for information
about replacing the Mini-PIMs.
A Mini-PIM has failed. Mini-PIM
109 Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Troubleshooting Components