10. Enable telnet service.
[edit]
root@#
set system services telnet
NOTE:
When Telnet is enabled, you cannot log in to a QFX5200 switch through Telnet using root credentials.
Root login is allowed only for SSH access.
11. Enable SSH service for root login.
[edit]
root@#
set system services SSH
12. Commit the configuration to activate it on the switch.
[edit]
root@#
commit
QFX5200-32C and QFX5200-32C-L Safety Warning Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the QFX5200 hardware
documentation at
https://www.juniper.net/documentation/product/en_US/qfx5200
WARNING:
Failure to observe these safety warnings can result in personal injury or death.
•
Permit only trained and qualified personnel to install or replace switch components
•
Perform only the procedures described in this quick start and the QFX5200 documentation. Other services must be
performed only by authorized service personnel.
•
Before installing the switch, read the planning instructions in the QFX5200 documentation to make sure that the site
meets power, environmental, and clearance requirements for the switch.
•
Before connecting the switch to a power source, read the installation instructions in the QFX5200 documentation.
•
The QFX5200-32C and QFX5200-32C-L weighs approximately 23.5 lb (10.66 kg). Manually installing the QFX5200-32C
and QFX5200-32C-L in a rack or cabinet at a height above 60 in. (152.4 cm) requires two people to lift the switch and
install mounting screws. To prevent injury, keep your back straight and lift with your legs, not your back.
8
