Juniper QFX5100, Руководство по оборудованию

Страница: 75 / 256

Related
Documentation
Connecting a QFX Series Device to a Management Console on page 180
•
Management Port Connector Pinouts for the QFX Series
The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect to either
the control plane and management network in a QFabric system, or a management
device for out-of-band management.
Table 19 on page 57 provides the pinout information of the RJ-45 management port
connector. An RJ-45 cable is supplied with the QFX Series device.
Table 19: RJ-45 Management Port Connector Pinouts for the QFX Series
Description Signal Pin
Transmit/receive data pair 1 TRP1+ 1
Transmit/receive data pair 1 TRP1– 2
Transmit/receive data pair 2 TRP2+ 3
Transmit/receive data pair 3 TRP3+ 4
Transmit/receive data pair 3 TRP3– 5
Transmit/receive data pair 2 TRP2– 6
Transmit/receive data pair 4 TRP4+ 7
Transmit/receive data pair 4 TRP4– 8
Related
Documentation
Management Port LEDs on a QFX3100 Director Device
•
•
Management Port LEDs in the QFX3600 and QFX3600-I Device
•
Management Port LEDs on a QFX3500 Device
•
Management Port LEDs on a QFX5100 Switch on page 215
Interface Support for the QFX5100 Switch
All product SKUs of the QFX5100 supply four quad small form-factor pluggable plus
(QSFP+) ports for use as uplinks, as access ports, or as Virtual Chassis ports (VCPs).
These 40 GbE ports support QSFP+ transceivers, QSFP+ direct-attach copper (DAC)
cables, and DAC breakout cables (DACBO). The QFX5100-48S has 6 QSFP+ ports; the
QFX5100-96S has 8 QSFP+ ports; the QFX5100-24Q has 24 built-in QSFP+ ports that
can all be used as uplinks. The You can also add two QFX-EM-4Q expansion modules
to the QFX5100-24Q for additional QSFP+ uplink ports. Each QSFP+ port on a
QFX5100-24Q can be configured to operate as 10-Gigabit Ethernet interface by using a
57 Copyright © 2014, Juniper Networks, Inc.
Chapter 8: Port and Interface Specifications