Juniper QFX5100, Руководство по оборудованию

Страница: 74 / 256

NOTE: Executing the request system snapshot CLI command on a QFX3500
device requires an external USB flash drive with at least 4 GB of free space.
We recommend using the RE-USB-4G-S flash drive.
NOTE: USB flash drives used with the QFX Series device must support
USB 2.0 or later.
Related
Documentation
Creating an Emergency Boot Device for a QFX Series Device on page 225
•
•
Performing a Recovery Installation on a QFX5100 Switch on page 227
Console Port Connector Pinouts for the QFX Series
The console port (labeled
CON
,
C1
, or
CONSOLE
) is an RS-232 serial interface that uses
an RJ-45 connector to connect to a console management device. The default baud rate
for the console port is 9600 baud.
Table 18 on page 56 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and RJ-45 to DB-9 adapter are supplied with the QFX Series device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a QFX Series device, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
Table 18: Console Port Connector Pinouts for the QFX Series
Description Signal Pin
Request to send RTS Output 1
Data terminal ready DTR Output 2
Transmit data TxD Output 3
Signal ground Signal Ground 4
Signal ground Signal Ground 5
Receive data RxD Input 6
Data carrier detect DCD Input 7
Clear to send CTS Input 8
Copyright © 2014, Juniper Networks, Inc. 56
QFX5100 Switch Hardware Guide